Eos PNA power and data
Eos PNA power and data interface is a special unit that connects straight to User port on Eos device.
Learn more


It has 5V power supply on USB connector for charging your PNA.It also converts TTL levels of serial communication to RS232 levels suitable for PNAs.

On one side there is a 5pin USB mini B connector. Use this to connect to your PNA. On other side there is 6-pin RJ11 cable. You should connect this to USER port on LX Eos.

Note: Some PNAs (e.g. Vertica) are using 10 pin USB mini-B connectors. Use 5-pin to 10-pin extension cable which is usually supplied with the PNA device.

USB mini B pinout:

Pin 1 = +5V
Pin 2 = RX
Pin 3 = TX
Pin 4 = +5V
Pin 5 = GND


  • Variometer, TE compensation by TE probe or electronic way
  • Speed-to-fly function
  • Final glide calculator based on GPS data!
  • Simple navigation to TP and TSK
  • High level IGC approved flight recorder
  • Flarm radar screen (ADSB and Flarm Traffic)
  • Thermal assistant screen
  • System extensions: Second seat configuration, Remote control operation ( LX Joy)
  • Logbook
  • Flight information with Barograph
  • Multi pilot support
  • Accurate wind calculation in straight flight and circling